Introduction: If you are working with Allen-Bradley PLCs and using Studio 5000, you might need to connect it with RS Linx and Emulator for testing and programming. In this guide, I will show you the step-by-step process to set it up easily.
Step 1: Install the Required Software
Before starting, make sure you have these installed: ✅ Studio 5000 Logix Designer ✅ RS Linx Classic ✅ Studio 5000 Emulator
If you don’t have these, download and install them from Rockwell Automation’s official website.
Step 2: Open RS Linx Classic and Configure Communication
Launch RS Linx Classic.
Click on “Communications” → “Configure Drivers”.
From the list, select “Virtual Backplane (SoftLogix)” and click Add New.
Name the driver (e.g., Emulator Driver) and click OK.
Your Emulator should now appear in RS Linx.
Step 3: Open Studio 5000 Emulator
Launch Studio 5000 Logix Emulator.
Click on Slot 2 (or any empty slot) → Create Module.
Select 1756-L71 Emulator Controller and click OK.
Set a name for the controller and click Finish.
Step 4: Open Studio 5000 and Create a New Project
Open Studio 5000 Logix Designer.
Click New Project → Select 1756-L71 Emulator.
Give a name to your project and click Create.
In the Controller Properties, set the Chassis Type to match the emulator.
Click OK.
Step 5: Configure the Communication in Studio 5000
Go to Controller Organizer → Right-click I/O Configuration.
Select New Module → Choose 1756-EN2T (Ethernet module).
Set the slot number same as the emulator.
Click OK.
Step 6: Download and Test the Connection
Click on Who Active in Studio 5000.
Select Emulator Driver in RS Linx.
Click Download → Wait for it to load.
Click Go Online to test the connection.
🎉 You’re Done! Now you can test and run PLC programs in the emulator without actual hardware.
Conclusion
By following these steps, you can successfully connect Studio 5000 with Emulator and RS Linx for smooth PLC programming and simulation. If you found this guide helpful, share it and leave a comment below! 😊
👉 Watch the Full Video Tutorial Here:
Post a Comment